1074 - AC Motor Speed Controller (230Vac/50Hz, 600W)

Reliable and simple to install project that allows you adjust the speed of a 230Vac/50Hz mains powered electric drill or single phase brushed induction motor rated up to 600 Watts maximum. Simply turn the potentiometer to adjust the motors RPM.

Uses a proven diac/triac based circuit. Onboard safety fuse. Heatsink included.

Please note that some loss of power occurs at low RPMs.

PRODUCT SELECTION NOTES: The motor controller should have an output load capacity at least 25% above the motors peak power requirement. Please do NOT rely on motor rating plates for power consumption figures as they often quote average not peak power. You should verify the actual peak power at start-up and under full load before selecting an appropriate size motor controller. Not suitable for use with brushless AC motors and capacitor-start/run AC motors.

Technical Specifications
Working voltage	230Vac/50Hz mains
Maximum Output Power	600 Watts (3.0Amps @ 230Vac)
Board Dimensions	65 x 48 x 25mm
Enclosure	WCAH2853
Board Connections	Solder Posts
Product Formats	SELF-ASSEMBLY Electronic Kit (KT ) or PRE-ASSEMBLED Electronic Module (AS) more
Documentation	User Manual
WARNING!	This product operates at potentially lethal mains voltage. Construction, installation, testing and commissioning should only be attempted by competent persons, or under supervision of someone fully experienced in this field. Many areas of the assembly (including heatsinks) may operate at mains voltage. It must be fitted into a suitable isolating enclosure to avoid injury or death. This product is not suitable for children. more

• Not suitable for use with brushless AC motors and capacitor-start AC motors.
• Kit version includes solder for assembly