CR0035 - DC Motor Controller (External-Signal/Potentiometer) Module (8-30V / 25A)

This external signal (0-10Vdc) or potentiometer operated DC motor speed controller uses a PWM triac output and allows you to adjust the speed of single-phase, universal DC motors with 8 - 30V dc supply and an operating load of up to 25 Amps.

Motor speed adjustment is from 0 to 100% is achieved using either an external 0-10V dc control signal or a 10K potentiometer (not included).

Signal input operation can be set so the output is either directly or inversely proportional to the control signal.

Please see User Manual below for full description.

PRODUCT SELECTION NOTE: This module can be used to control DC resistive loads like lights, machinery pedals, universal motors, control automation, modelling, etc… . It is NOT suitable for use with inductive loads like neon's, halogen lamps, transformers, etc,..  The motor controller should have an output load capacity at least 25% above the motors peak power requirement. Please do NOT rely on motor rating plates for power consumption figures as they often quote average not peak power. You should verify the actual peak power at start-up and under full load before selecting an appropriate size motor controller.

Please see CR0025 for an 8A version of this product.

Technical Specifications
Operating Voltage	8V - 30V dc
Output  Load	25.0A maximum
Module Power Consumption	30 - 150mA
Control signal voltage	0 - 10V dc
External potentiometer	10K Ohm
Polarity Protection	Yes
Dims. (HxWxD) mm	124 x 113 x 55 mm
Product Format	Pre-Assembled electronic module
Documentation	User Manual

• An optional set comprising a 10K linear potentiometer and control knob is available for purchase suitable for use with this module