CR0026 - AC Motor Speed Controller (External-Signal/ Potentiometer) Module (230Vac, 2500W)

This external signal (0-10Vdc) or potentiometer operated AC motor speed controller uses a triac output and allows you to adjust the speed of 230Vac single-phase induction motors as used in power drills, vacuum cleaners, etc and an operating load of up to 2500 Watts.

Motor speed adjustment is from 0 to 100% is achieved using either an external 0-10V dc control signal or a 10K potentiometer (not included).

Signal input operation can be set so the output is either directly or inversely proportional to the control signal.

Please see User Manual below for full description.

PRODUCT SELECTION NOTE: This module can be used to control the speed of 230Vac single-phase induction motors, light regulators, 230V signals through automatisms, etc… It is NOT suitable for use with synchronous AC motors or inductive loads like halogen or PL lamps, neon, etc.. The motor controller should have an output load capacity at least 25% above the motors peak power requirement. Please do NOT rely on motor rating plates for power consumption figures as they often quote average not peak power. You should verify the actual peak power at start-up and under full load before selecting an appropriate size motor controller.

Suitable for use with DIN-RAIL Mounting (Order Code CC7567).

Please see CR0027 for a 5000W version of this product.

Technical Specifications
Operating Voltage	230Vac mains
Output Load	2500 Watts maximum
Control signal voltage	0 - 10V dc
External potentiometer	10K Ohm
Output Load (Minimum)	50 Watts
Operating Voltage (Minimum)	90Vac
Dims. (HxWxD) mm	121 x 116 x 45 mm
Product Format	Pre-Assembled electronic module
Documentation	User Manual
WARNING!	This product operates at 230Vac mains voltage. Connection, testing and use of the product should only be attempted by competent persons, or under supervision of someone fully experienced in this field. Product must be fitted into a suitable enclosed box before operating. more

• An optional set comprising a 10K linear potentiometer and control knob is available for purchase suitable for use with this module