CR0018 - AC Motor Push-Button Speed Controller Module (230Vac, 750W)

This push-button operated AC motor speed controller uses a triac output and allows you to adjust the speed of 230Vac single-phase induction motors as used in power drills, vacuum cleaners, etc and an operating load of up to 750 Watts.

Motor speed adjustment is achieved using either a single or pair of push-button switches (not included). These are used to control the motor speed in steps (with user adjustable ramp speed), continuously or immediately.

In two-button mode the circuit provides immediate and complete activation / deactivation if buttons are pushed and held. The circuit also features a memory that allows the motor to be returned to a previously set speed.

In single-button mode the output will cycle from fully on to fully off. A fast button press will completely activate / deactivate depending on where it is in the cycle.

Please see User Manual below for full description.

PRODUCT SELECTION NOTE: This module can be used to control control 230Vac single-phase induction motors, lights, machinery pedals, digital control in panel lighting, etc… It is NOT suitable for use with synchronous AC motors or inductive loads like halogen or PL lamps, neon, etc.. The motor controller should have an output load capacity at least 25% above the motors peak power requirement. Please do NOT rely on motor rating plates for power consumption figures as they often quote average not peak power. You should verify the actual peak power at start-up and under full load before selecting an appropriate size motor controller.

Please see CR0019 for a 1500W version of this product.

Technical Specifications
Operating Voltage	230Vac mains
Output Load	750 Watts maximum
Output Load (Minimum)	50 Watts
Operating Voltage (Minimum)	90Vac
Dims. (HxWxD) mm	72 x 98,75 x 45 mm
Product Format	Pre-Assembled electronic module
Documentation	User Manual
WARNING!	This product operates at 230Vac mains voltage. Connection, testing and use of the product should only be attempted by competent persons, or under supervision of someone fully experienced in this field. Product must be fitted into a suitable enclosed box before operating. more