230Vac/50Hz Motor Speed Controller Modules (CR0008/CR0009/CR0010)

This range of motor speed controllers allow you to adjust the speed of 230Vac/50Hz single-phase induction motors as used in power drills, vacuum cleaners, etc. Speed adjustment is controlled using Phase Angle Regulation (PAR) and a Triac output and a potentiometer mounted on the board. The speed adjustment range is from 33 to 98% and an onboard trimmer provides minimum speed adjustment.

Models for 375W, 750W and 1500W operating loads are available in this range.

All modules are supplied fully assembled and tested with instructions so you only need to make the necessary connections.

PRODUCT SELECTION NOTES: Suitable for controlling most 230Vac/50Hz single-phase induction motors, filament lamps, etc... They are NOT suitable for use with synchronous AC motors, capacitor-start/run AC motors or inductive loads like halogen or PL lamps, neon, etc.. Ask the manufacturer to confirm if their motor is suitable for control using a Phase Angle Regulation (PAR) style controller BEFORE you buy this product! The motor controller should have an output load capacity at least 25% above the motors peak power requirement. Please do NOT rely on motor rating plates for power consumption figures as they often quote average not peak power. You should verify the actual peak power at start-up and under full load before selecting an appropriate size motor controller.

Technical Specifications
375W Controller	CR0008 User Manual
Operating Voltage	230Vac/50Hz mains
Output Load	375 Watts maximum
Output Load (Minimum)	50 Watts
Operating Voltage (Minimum)	90Vac
Board Dimensions (mm)	~ 60 x 55 x 38
Enclosure	WCAH2851
Control Knob	KB0561
Fuse Holder	787.398
Fuse	787.263
EMI Filter	CC8202
750W Controller	CR0009 User Manual
Operating Voltage	230Vac/50Hz mains
Output Load	750 Watts maximum
Output Load (Minimum)	50 Watts
Operating Voltage (Minimum)	90Vac
Board Dimensions (mm)	~ 60 x 55 x 38
Enclosure	WCAH2851
Control Knob	KB0561
Fuse Holder	787.398
Fuse	787.266
EMI Filter	CC8202
1500W Controller	CR0010 User Manual
Operating Voltage	230Vac/50Hz mains
Output Load	1500 Watts maximum
Output Load (Minimum)	50 Watts
Operating Voltage (Minimum)	90Vac
Board Dimensions (mm)	~ 60 x 55 x 38
Enclosure	WCAH2851
Control Knob	KB0561
Fuse Holder	787.398
Fuse	787.019
EMI Filter	CC8202

• Enclosure (all models): Order Code WCAH2851
• Control Knob (all models): Order Code KB0561
• fuse Holder: Order Code 787.398
• Fuses: See User Manual for appropriate value
• Mains interference filter: Order Code CC8202

• WARNING! These products operate at potentially lethal mains voltage. Installation, testing and commissioning should only be attempted by competent persons, or under supervision of someone fully experienced in this field. Many areas of the assembly (including heatsinks) may operate at mains voltage. It must be fitted into a suitable isolating enclosure to avoid injury or death. This product is not suitable for children. more

• Please note that we will not ship this item to customers outside of Europe