3179 - Standalone / Computer Controlled Unipolar Stepper Motor Driver

Drives any 5, 6 or 8-lead unipolar stepper motor rated up to 6A (5 - 35Vdc) in either Free-Standing or Computer-Controlled mode for CNC type applications.

Free-Standing mode provides motor speed control using an onboard trimmer and direction control is via an onboard switch. (internal oscillator)

Computer-Controlled mode provides direction and step control using pulses from the computer parallel printer port and can be used with a wide variety of CNC control software packages. Up to six 3179 driver boards (for controlling 6 motors) can be connected to a single PC parallel port.

Uses IRFZ44 power MOSFETs to drive the motors. These MOSFETs have a low on resistance and can carry 6 Amps each without a heatsink. Uses discrete logic ICs (4013, 4030, 4093).

Separate power connections are provided for the board and motor supplies. Screw terminal blocks and solder pins for connections.

Full operational details provided (see User Manual link below).

Technical Specifications
Board Supply	9-Regulated 12Vdc (Order Code PSU446 with connector 778.106)
Motor Supply	5 - 35Vdc (see Power Supplies section)
Motor Current	6 Amps maximum per phase
Motor Types	5, 6 or 8-lead unipolar stepper motors
Computer Interface	Parallel port (for computer control)
Overall Dimensions	~ 80 x 50 x 22 mm
Enclosure	WCAH2855
Connections	Screw terminal blocks and solder pads
Product Formats	SELF-ASSEMBLY Electronic Kit (KT ) or PRE-ASSEMBLED Electronic Module (AS) more
Documentation	User Manual