30A96020 - Dual 20 Second Message / Sound Recorder Module

The 30A96020 is a high quality voice/sound recording module in a small, low cost, ready assembled package that provides recording and playback of two 20 second messages using separate buttons.

It is ideal for model enthusiasts as it is so small and lightweight. The message or sound is stored in non-volatile memory so is retained even when it is turned off. You can erase and record a new message as many times as you like.

See Order Code 30A63 for a single message version of this product.

Features

• Non volatile flash memory technology
• No battery back up required
• User friendly, easy to use operation
• Slide switch for record or play back
• Separate key to trigger message 1 or 2
• Low power consumption
• LED to indicate recording and playback
• Built-in condenser microphone
• Automatic power down
• 5V Operation (use Order Code AS3060-05 if required)
• Can be used with our 1W audio amplifier (Order Code 3017) for greater sound levels.

Press PLAY button to play message once; press again during playback to stop; or hold down for looped playback (with a 1 second pause). 2 x 20 seconds of audio can be recorded at the factory set sampling rate of 3.2KHz but up to 30 seconds record time (at 2.0KHz) can be achieved by simply changing one resistor.

Technical Specifications
Supply	Regulated 5Vdc (4.5V Min, 6.5V Max) (Order Code AS3060-05) - DO NOT EXCEED 6.5Vdc! 4 x 1.5V batteries could destroy the module!!
Operating Current (8 Ohm speaker)	45mA recording / 70mA playback
Standby current	200uA typical (250uA max.)
Storage capacity	2 x 20 seconds @ 3.2KHz (standard setup)
Output	8-16 Ohm speaker (Order Code 4047)
Board Dimensions	34x23mm
Product Format	Fully assembled module more
Documentation	User Manual