30A63 - 20 Second Message / Sound Recorder Module

Small, low cost, ready assembled voice/message recorder based around a COB PCB.

It is ideal for model enthusiasts as it is so small and lightweight. The message or sound is stored in non-volatile memory so is retained even when it is turned off. You can erase and record a new message as many times as you like.

See Order Code A96020 for a dual message version of this product.

Features

• Non volatile flash memory technology
• No battery back up required
• User friendly, easy to use operation
• 2-keys operation, Record and Play
• Low power consumption
• LED to indicate recording
• Built-in condenser microphone
• Automatic power down
• 5V Operation (use Order Code AS3060-05 if required)
• Can be used with our 1W audio amplifier (Order Code 3017) for greater sound levels.

Press PLAY button to play message once; press again during playback to stop; or hold down for looped playback (with a 1 second pause). 20 seconds of audio can be recorded at the factory set sampling rate of 6.4KHz but up to 30 seconds record time (at 4.0KHz) can be achieved by simply changing one resistor.

Technical Specifications
Supply	Regulated 5Vdc (4.5V Min, 6V Max) (Order Code AS3060-05) - DO NOT EXCEED 6Vdc!
Operating Current	25mA typical (no load)
Standby current	5uA typical (10uA max.)
Storage capacity	20 seconds @ 6.4KHz (standard setup)
Output	8-16 Ohm speaker (Order Code 4047)
Board Dimensions	34x23mm
Product Format	Fully assembled module more
Documentation	User Manual